Ozone Generator - Maintainability

Clean up the Ozone Plate:

  1. Screw down the lid. To remove the black lid. Users will see the module of Ozone Plate.

              

  2. Pulling the module uses thumb or forefinger. The Ozone Plate could be took off easily. Then, screw down the plate.

                     

  3. To take out the plate lightly.

             

  3. The plate could be rinsed with water. Please do not over 10 seconds and do not rub the plate too hard. To clean the surface of plate just need some water and lightly rubbing. After all, MUST dry the plate before setting it back.

Caution: DO NOT INSERT THE MOIST PLATE. PLEASE NEVER DO THAT!!!

             

  3.  Put the plate back to the module. Please make sure the plate flat with the module and the metal heat sink. After two conditions above, screw the plate with the black lid.

                   

  4. To insert the dried Ozone Plate. Please make sure the Ozone Plate is inserted straight and flat with the out shell.

              

  5. Screw the black lid back. Finished.

       

 

Clean up the Filter:

  1. To take off the black shell of filter. It can be removed by hands easily. Users can see the filter under the shell.

             

  2. To rinse the filter with water. After that, please dry the filter.

             

  3. To put the filter and shell back to the machine. Finished.